RCS ZWAVE COMPATIBLE THERMOSTAT

Z-WAVE COMPATIBLE WITH DUAL SETPOINTS

The RCTZ16 thermostat consists of three parts, a Wall Display Unit (WDU), the HVAC Control Unit and the ZWBT Z-Wave Thermostat adapter. The Wall Display Unit provides users functions like a traditional thermostat and connects to the Control Unit by a 4 wire cable. The Control Unit connects at the HVAC system using the standard thermostat connections and provides the thermostatic temperature control of the system. The ZWBT provides connection to the Z-Wave Network.

This system maintains separate heating and cooling set points. The display shows the set point of the current operating mode (in Auto mode, the system keeps track of the current operating mode of the last call, either heating or cooling). In addition to the universal Standard or Heat Pump HVAC systems support, the RCTZ16 has multistage heating/cooling system outputs. The control unit can support 2 stages of heating and cooling for Standard systems. It supports 3 stages of heating and 2 stages of cooling for Heat Pump systems.

The RCTZ16 has a convenient setup mode from the Wall Display Unit. You can set the network address, F or C display mode and easily calibrate the internal and all attached remote sensors. The RCTZ16 has automatic detection and setup of remote temperature sensors. Remote sensors have address settings that, when detected by the RCTZ16, will be used for specific functions, such as, in lieu of the internal sensor, averaging with other sensors or an outdoor temperature sensor. The RCTZ16 can be used with system controllers that support the Z-Wave thermostat protocol.

THE STAT FOR ALL STANDARDS

The RCS communicating thermostats function as stand alone thermostat subsystems with communications to allow remote data acquisition and control of the units. All thermostat functions can be monitored or controlled via network commands. The only thermostat family that makes retrofit installation a snap. No new wires needed to run out to the thermostat wall location. Unique, industry leading two part design places the thermostat control unit at the mechanical system and a wall display unit at the thermostat on wall location. Uses only four wires to interconnect the two units.

• Separate Heating and Cooling set points.
  
• Multistage heating ventilation & air conditioning (HVAC) systems support.
  
• Wall Display Unit setting of Network Address.
  
• °F/C temperature display mode.
  
• Sensor calibration (internal and remotes).
  
• Displays temperatures from -9°F/C to +127°F/C.
  
• Automatic Remote Sensor detection.
  
• Supports the latest Z-Wave thermostat protocol.

Dimentions:

• Thermostat control unit: 7.7" x 5.75" x 1.5";
  
• Wall display: 3 1/8" x 4 3/4" x 7/8"
  
• Temperature Range: -9° F to 127° F